Search This Supplers Products:Automobile PartsAuto Engine PartsAuto Suspension PartsAuto Electric FanAuto CarburetorEngine Turbocharger
A. If any of the following conditions have occurred:Changing to a larger tire on your truck Reduction in the vehicle?s wheelcut has taken place Pitman arm was mistimed, and has been corrected Steering gear is being installed on a different truck Steer axle stop bolt(s) were bent or broken Steer axle u-bolt(s) were bent or broken Incorrect alignment procedures are used (i.e. Removal of an axle stop...
timeTue, 21 Aug 2012 13:31:22 GMT
A. Poppets are pressure unloading valves set to trip just before full turn is reached in each direction. When this procedure is completed correctly, system pressure will be reduced before the axle stop screw contacts the axle stop in both directions
timeTue, 21 Aug 2012 13:30:35 GMT
A. When the pump relieves, it relieves the heated oil back into the inlet of the pump and not the reservoir. This oil temperature exceeds the 250 ?F shaft seal tolerance
timeTue, 21 Aug 2012 13:29:59 GMT
A. The poppets are not operating when the wheels are turned full left and right to the axle stop (for an extended period). The pump relief valve is working all the time and creates an overheating condition in the system when the poppets are not working. Check that axle stops are set to OEM specifications and reset the poppets. 1? clearance is recommended. See Poppet resetting procedures TAS101 Ser...
timeTue, 21 Aug 2012 13:29:29 GMT
网络文化经营许可证:浙网文[2013]0268-027号|增值电信业务经营许可证:浙B2-20080224-1 2007-2024 Tradevv.com. All rights reserved.